I’ve recently stumbled upon ayvri.com a new website (initially called doarama.com) to visualize your flight paths in a 3D map, alongside the original drone video. Even tough the website is till beta, it looks really awesome. Here is my Zaggometry test flight from last summer. Check it out!
All I needed to provide was the GPS coordinates of the Discovery Pro drone in .gpx format and a link to the corresponding youtube video. This is pretty simple.
You can swap the position of the video and 3D map, by clicking the smaller one. The visualization needs WebGL, which is fine with Firefox and Chrome and Internet Explorer. In Safari it first needs to be enabled.
The Zaggometry is a clever little piece of electronics which can read the NAZA GPS coordinates of you copter and send it over the telemetry link down to your Taranis RC-remote for display and logging. In other words, it is a bit like a Flytrex Live flight recorder for your Taranis. The 29€ Zaggomety was developed and is produced(!) by Eberhard Rensch in Germany. In this article I would like to show how I installed it in my TBS Discovery Pro and the data I logged during a test flight (video).
Continue reading Zaggometry: How to log your flights with the Taranis →
I usually never change a running system but I wanted to play with some new telemetry sensors and all the new LUA scripting features of the openTX 2.0 on my TBS Disco Pro. This is (not yet) an official FrSky firmware. They are stuck at some older, feature restricted 1.x version and they might never offer some of the newer features, as they consider the Taranis a feature complete product. Well, I don’t.
Continue reading Taranis upgrade to openTX 2.0 →
The official instructions for binding the X8R receiver to the Taranis are quite confusing and cryptic. Therefore, I try to give step by step instructions about how to bind them in the different available modes as well as some background information. The whole process is split into a preparation phase, mode selection and a binding procedure.
Continue reading How to bind X8R to the FrSky Taranis in different modes →
In the third part of the build log I would like to cover the setup and configuration of the Taranis RC with the TBS Discovery Pro. After covering the mechanical build in part 1 and part 2 of the build log, this part will be about the wiring and programming of the remote control. Due to a crash I’ve build the copter a 2nd time.
Detailed setup guide and model files to download after the break. Continue reading Build Log: Taranis and TBS Discovery Pro, Part 3 →
First Person View quadcopters
